For further information please refer to data sheet.
LNA is connected to
Port 5
Input voltage
3 V ... 5.5 V
Current cunsumption
45 mA
Noise figure
2 dB
Total gain @90° elevation
38 dBic
Remarks
This Antenna is compliant with the Radio Equipment Directive 2014/53/EU
EMC: EN50121-3-2 (2016)
Values for LNA power consumption, noise figure and gain are given for a 5V operating voltage and may differ slightly for a lower voltage
Remarks
Ground plane: VSWR and gain values are based on a reference ground plane of 1000x500mm. The tolerance of the VSWR and Isolation values is 0.5dB. The Cellular and Wi-Fi 6E bands from 4900 - 7125 MHz are supported on the vertically polarized ports (no ground plane requirements). The isolation values are valid only for the ports with common bands. The best indicator for the actual antenna performance is the average combined condition number.
The isolation values mentioned on page 1 refers to the isolation between Port 1 (vertical) and Port 2 (horizontal). The Isolation limit values between the other ports are below:
Port 3 (vertical) to Port 4 (vertical):
Frequency 617-960 MHz, Isolation: 16dB
Frequency 1425-2700 MHz, Isolation: 22dB
Frequency 3300-7125 MHz, Isolation: 25dB
Port 3 (vertical) to Port 2 (horizontal):
Frequency 694-960 MHz, Isolation: 23dB
Frequency 1515-2700 MHz, Isolation: 30dB
Frequency 3300-4200 MHz, Isolation: 35dB
Port 4 (vertical) to Port 2 (horizontal):
Frequency 694-960 MHz, Isolation: 21dB
Frequency 1515-2700 MHz, Isolation: 29dB
Frequency 3300-4200 MHz, Isolation: 33dB
Port 1 (vertical) to Port 3 (vertical):
Frequency 617-960 MHz, Isolation: 26dB
Frequency 1425-2700 MHz, Isolation: 27dB
Frequency 3300-7125 MHz, Isolation: 30dB
Port 1 (vertical) to Port 4 (vertical):
Frequency 617-960 MHz, Isolation: 26dB
Frequency 1425-2700 MHz, Isolation: 27dB
Frequency 3300-7125 MHz, Isolation: 30dB
High-voltage-protection: no voltage on RF port, if the catenary line touches the antenna (EN 50124-1, 3.8 kVDC, 27.5 kVAC, 1min).
High-current-protection: Designed acc. to UIC 533, DC-grounded antenna element (protection against lightning and short circuit with catenary lines(40kA/0.125s)
Weight
7.9 kg
Dimensions
90 mm x 508.7 mm x 411.7 mm (Height x Width x Depth)
Remarks
Mounting: Shall be installed in longitudinal position to the wind/driving direction.
Suitable for installation on high-speed trains with a maximum speed of 500 km/hr.
4x composite sealing washers included for silicone-free sealing of the mounting screws.
Corrosion: Low corrosion design acc. to MIL-DTL-14072(E), 96 hours Salt Spray test.
